GT POWER GT3500SE, Руководство по эксплуатации

Страница: 9 / 28

8. 9. www.gtpower.co.nz
www.gtpower.co.nz
GT3500SE
Oil Warning Light
When the oil level falls below the lower
level, the oil warning light comes on and
then the engine stops automatically. Unless
you refill with oil, the engine will not start
again.
TIP: If the engine stalls or does not start,
turn the engine switch to “ON” and then
pull the recoil starter. If the oil warning light
Overload Indicator Light (Red)
The overload indicator light comes on when
an overload of a connected electrical device
is detected, the inverter control unit over-
heats, or the AC output voltage rises.
Then, the AC protector will trip, stopping
power generation in order to protect the
generator and any connected electric
devices. The AC pilot light (Green) will go off
and the overload indicator light (Red) will
stay on, but the engine will not stop running.
When the overload indicator light comes on
and power generation stops, proceed as
follows:
1. Turn off any connected electric devices
and stop the engine.
2. Reduce the total wattage of connected
electric devices within the rated output.
3. Check for blockages in the cooling air
inlet and around the control unit. If any
blockages are found remove.
4. After checking, restart the engine.
NOTE: The overload indicator light
may come on for a few seconds at
first when using electric devices that
U>
a: AC under-voltage, indicating the
character of AC (alternative indica
tion of AC and digit)
b: DC under-voltage, indicating the
character of DC (alternative
indication of DC and digit).
I>
Output over current of generator
Output short circuit of generator
Over heat of generator
Maintenance time
flickers for a few seconds, the engine oil is
insufficient. Add oil and restart.