GT POWER GT3500SE, Руководство по эксплуатации

Страница: 10 / 28

10. 11. www.gtpower.co.nz
www.gtpower.co.nz
GT3500SE
Preparation before
Operating
NOTE: Pre-operation checks should
be made each time before operating.
WARNING: The engine and muffler
will be very hot after the engine has
been running. Avoid touching the
engine and muffler while they are
still hot with any part of your body or
clothing during inspection or repair.
AC Pilot Light (Green)
The AC pilot light comes on when the
engine starts and produces power.
DC Protector
The DC protector turns “OFF” automatically
when an electric device connected to the
generator is operating over peak wattage. To
operate the equipment again, switch the DC
protector button to “ON”.
NOTE: Reduce the load of the
connected electric device below the
specified rated output of the generator
if the DC protector turns off. If the DC
protector turns off again, stop using
device immediately and consult your
nearest GT POWER Dealer.
Ground (Earth) Terminal
The Ground (Earth) terminal (9) purpose is
to connect the generator frame to a ground-
ing point such as an earth stake to prevent
against electric shock from the generator
frame in the case of a short circuit or other
electrical malfunction of the generator or
the connected load. It is not required to be
connected for operation of the generator,
it is an additional safety feature. If in doubt
if grounding protection is required for your
application, please check with a registered
electrician as to your local regulations.
Brake
During the operation and idle periods of the
generator, brake timely and switch to
“STOP”. If the machine needs to be moved,
switch the brake to “RUN”
require a large starting current, such
as a compressor or a submergible
pump. However, this is not a malfunc-
tion.