GST GST-NRP00, Инструкция по установке и эксплуатации, Страница: 8 / 32

GST-NRP00/GST-NRP00-HU/GST-NRP00-PT
Network Repeater Panel Installation and Operation Manual
the fault condition is removed.
DISABLE: Yellow. It illuminates when the repeater panel receives, from FACPs in
network, disabled messages of connected devices, FP.E. output or SOUNDER
CIRCUIT OUTPUT. It goes out when such status is canceled.
SYSTEM FAULT: Yellow. It illuminates if the program encounters a dead halt. After
the system is rebooted, only by pressing
RESET , can system fault be cleared, and
this LED goes out.
PRE-ALARM: Red. It illuminates if there is pre-alarm message.
POWER ON: Green. It illuminates when system power is normal.
POWER FAULT: Yellow. It illuminates when the repeater panel receives message
of fault with FACPs in network. After the fault is cleared, it will go out.
F.P.E. FLT/DISABLE: Yellow. It flashes when the repeater panel receives message
of fault with F.P.E. output and illuminates steadily after the F.P.E. is disabled. It
goes out after the fault and disabled conditions are cleared.
SOUNDER FLT: Yellow. It illuminates when the repeater panel receives message of
fault with the SOUNDER CIRCUIT OUTPUT of FACPs in network. It goes out
automatically after the fault is cleared.
SOUNDER DISABLE: Yellow. It illuminates steadily after the SOUNDER CIRCUIT
OUTPUT of FACPs in network is disabled. It goes out automatically after the
disabled condition is cleared.
TEST MODE: Yellow. It illuminates when the repeater panel is under commission.
SILENCE: Yellow. It illuminate after
SILENCE key is pressed, and goes out when
RESET key or EVAC key is pressed.
EVAC: Red. It illuminates after EVAC key is pressed and goes out when RESET or
SILENCE key is pressed.
3.1.2 Description of Keys
SYSTEM: System set-up key (manager password required), used for setting
system time, modifying operator password and manager password, setting network
system, and system initialization.
TEST: Self-test key (operator password required). Pressing this key in normal
standby state can self-test the audible and visual indication.
MODE: Mode setting key (operator password required). Pressing this key can set
the LCD contrast, message display modes, manually start device and manually
stop device.
TAB: For switching different type of messages in display screen; for moving the
cursor under input screen.
RESET: Resetting the repeater panel or FACPs in network (operator password
required).
BROWSE: Browsing network information.
Page 5