GSM mistral ML506, Инструкция по эксплуатации

Страница: 5 / 8

5
Installing The Duct
1. Outlet Louvre: A 130 mm diameter hole is
required for the outlet louvre (see template
below). Use 4 screws appropriate for the
mounting surface to secure it in place.
NOTE: The vent louvres should be
facing downwards, preventing water
from running into the duct.
65 mm
OUTLET LOUVER TEMPLATE
2. Duct Connection: Fully extend 3m duct to
minimise airflow restrictions then cut to fit
components. To cut duct use a sharp knife
for the silver walls and wire cutters for the
wire support coil. Plan the duct-run to be as
straight as possible. The fewer obstacles that
the duct has to weave around, the better! Do
not squash or force duct through tight bends.
in house end of the duct fix to the outlet of
fan motor housing, and fix another end of
duct to vent louvres with metal clip.
Electrican’s Wiring
Instructions
Your Mistral Bathroom Heater requires a 220-240
Volt, 50Hz electrical supply. All electrical work
must be carried out by a qualified electrician
and installed in accordance with relevant
Electrical Wiring Regulations.
Your new Mistral Bathroom Heater comes with all
required switches and mounting plates.
How
1. Decide the best position for the switch set and
mount it. Be sure to click the switches into the
backing plate in the desired order before
hand.
2. Connect wiring to switches as shown in the
appropriate electrical diagram.
3. Remove screws from terminal cover on the
Mistral Bathroom Heater and put aside.
Wire according to the label beside the
terminal strip. Once the wires are connected
incoming cable must not be fouled by cover.
Use appropriate knockouts in terminal cover
to accommodate cable before replacing.
Screw down firmly.