GSM mistral ML506, Инструкция по эксплуатации

Страница: 4 / 8

4
Mounting
For the purpose of obtaining best heating effect,
from the lamps there should be about 2.4m
overall height from ground.
1. Mark the ceiling with a pencil outline
370mm x 202 mm. BE SURE TO CHECK ABOVE
THE CEILING FOR MINIMUM SPACE OF 280mm
(for optimum performance allow 500mm or
more clearance) AND THE LOCATION OF
CEILING JOISTS. Ensure there is a minimum
of 100mm clear space between the Mistral
Bathroom Heater unit and any ceiling
insulation. Make sure distance between
edges to the wall is not less than 40mm.
Note: Before commencing cutting
ensure that the area behind the
intended location is clear of all cables,
pipes and joists.
2. Use a saw to cut the section along the drawn
lines.
3. Carefully remove the heater and accessories
from the plastic bag and carton. Please
assemble the air outlet before mounting the
unit into the hole. Air outlet assemble steps as
below:
4. Connect the ducting if required to the outer
grille of the unit. Insert the unit into the square
hole being sure to pull the side clips inward
so that the body can pass through the hole
without damaging the plaster Rotate the
swing clips to hold motor body in place(figure
1)then tighten screw to let the clip clamp
onto the ceiling board(figure 2).
5. Hold the fascia against the body of the heater
and the ceiling and attach the securing
spring clips to hold the fascia in place.
6. Now screw the two large heat lamps into the
lamp holder through the holes provided in
the fascia. The globes should be screwed up
firmly to ensure a good electrical contact but
don’t over tighten. Next fit the small centre
globe in the same way ensuring that it is
positioned centrally.