GSI Group PNEG-1813, Инструкция по установке и эксплуатации

Страница: 41 / 58

3. Operation Procedures
PNEG-1813 Electronic Distributor Control 41
3. Insert the desired value and press “enter”.
NOTE: Entering a value larger than the existing value will move spout position to the left,
entering a smaller value will move the position to the right.
4. Select “OK” to return to “Setup Menu”.
5. Verify spout alignment with distributor. See “Verifying Spout Alignment:” on page 35.
Offset All:
1. From the “Setup Menu”, select “Position Locations” to bring up the “Modify Spout
Positioning” screen.
2. In “Modify Spout Positioning” screen select the “0” key pad next to “OFFSET ALL”. A
number keypad will display (See Figure 3O.)
Figure 3O Number Keypad
3. Insert the desired offset value and press “enter”
To offset the spouts to the left, use a positive value and to offset to the right, use a
negative value.
NOTE: A maximum offset at any one time is +/- 5.
4. Select “OK” to return to “Setup Menu”.
5. Verify each spout alignment with distributor. See “Verifying Spout Alignment:” on
page 35.