GSI Group PNEG-1813, Инструкция по установке и эксплуатации

Страница: 35 / 58

3. Operation Procedures
PNEG-1813 Electronic Distributor Control 35
Move Screen
This screen allows the user to change the distributor’s current spout position. The green highlighted spout
number indicates the current selection. A spout number with a red circle with a line through it indicates a
position that is currently locked out (See “Position Lock-Out Screen” on page 42.)
NOTE: The default names for each spout will be “BIN #”, see “Position Names Screen” on Page 38 for
customizing the spout names.
Figure 3G Move Screen
Moving Spout Position:
1. From the “Main” screen or the “Setup Menu” select “MOVE” to view the “Move Position”
screen (See Figure 3G.) .
2. On the “Move Position” screen, select the position you want the spout to move to by
pressing the spout name on the screen.
3. The “Main Menu” screen will now display a flashing message “Moving to” at the top of
the screen, the selected spout number will flash yellow while the pointer is moving to
the selected spout. The destination spout number will turn green when the move is
complete.
Verifying Spout Alignment:
NOTE: In the following steps, the distributor must be in a position to view the spout
location in the distributor to verify that it lines up correctly. If the distributor is
installed above ground level, two people will be needed; one to verify the
alignment of the distributor spout and one to operate the controller.
1. From the “Main” screen or the “Setup Menu” select “MOVE” to view the “Move Position”
screen (See Figure 3G.)