USER MANUAL
76
5.4.5 IP FILTER
You are able to configure the
IP FILTER
for your NVR.
Enable:
Checking
Enable
allows you to setup the Whitelist and Blacklist
Enable Whitelists:
Whitelist is enabled by default, you must check
Enable
, before you can set
up the
Start Address
and the
End Address
of the Whitelist.
Start Address:
You can type in a start address then click
Single Add
, the Edit Address list is
show below.
End Address:
You can type in an end address then click
Network Segment Add
, the Edit
Address list is show below.
Edit:
Click
to edit Start Address and End Address, you may edit a single address or a network
segment address. You can also click
to delete a single address or a network segment
address.
Enable Blacklists: Blacklist
is disabled by default. You must check
Enable Blacklists
before
setting up your Blacklist. You may refer to your setup options for your Whitelist to edit the
Blacklist.
