STANDARD OPERATING CONDITIONS
It is recommended that
GruppoSTG Fabbrica Srl
modules be installed in "
Standard Operating Conditions
". It is advisable to avoid installation in conditions different from the conditions operational standards
defined "
Operating Conditions Specials
". The following are definitions of standard and special operating
conditions :
1.
Standard Operating Conditions
The
GruppoSTG Fabbrica Srl
module must only be used for land applications . It is not allowed to use in
space or in other "
special conditions
"
The temperature of operating the
GruppoSTG Fabbrica Srl
module must be comprised between the -40
° C and the + 40 ° C.
The limit of moisture relative permitted is up to 100 %.
The limit of altitude operative is fixed to 2500 mt s.lm, in case of altitudes more contact
GruppoSTG
Fabbrica Srl
for further information.
The modules are tested to resist to loads mechanical in pressure of 2400 N / m² and in traction of 2400 N
/ m². Check the installation for wind, snow and ice loads . It is necessary to use methods suitable
installation. If loads exceeding 2400 N / m² are expected for long periods, contact
GruppoSTG Fabbrica
Srl
for further information.
The modules are tested to withstand exposure to fire according to IEC 61730-2 (MST 23), class C.
2.
Special Operating Conditions
The temperature operational and the conditions of the place of installation are different from
the conditions operational standards.
In the place of installation the saline damage is maximum.
The local climate generates long periods of snow accumulation heavier than 2400 N / m² without
snow being removed regularly.
Warning
: careless handling of snow and ice and use with suitable
equipment can cause problems with the frame.
The local climate generates hailstorms with grains larger than 25mm in diameter.
The weather local generates storms of sand and dust for more than three days a year.
In the place of installation the values of pollution, active chemical vapors, soot, acid rain are at the
maximum values. Consult
GruppoSTG Fabbrica Srl
for areas in higher than normal concentrations
of gases such as NH
3
, H
2
S, C
x
H
y
in about requirements special of installation
