11
E N G L I S H •
User’s manual
form. Holding the workpiece in your hand or
against your body is unstable, and may lead to
loss of control.
• Keep your hands away of the motion parts.
• Always use goggles and dust mask when you
are grinding, specially when grind over your
head.
• Be careful with the sparks detached of the
disc when work. Hold the grinder such way
that the sparks fly away of you, other persons
or flammable materials.
• Don’t touch the work piece immediately af-
ter of the operation, could be very hot and can
cause hurts.
THE KICKBACK
The kickback is a sudden reaction. The punc-
tured or hooked produces a quick decrease
speed rate causing loose control of the tool
which is directed towards the side which is the
operator.
The kickback is the result of an inappropri-
ate tool use or an incorrect operation. Can be
avoided following these instructions:
1. Keep a firm grip with both hands on the
tool. Position your body properly to resist the
force of kickback. The operator can control
torque reactions if the correct warnings are
taken.
2. Never place your hand close to the rotating
accessory. It can cause a kickback over your
hand.
3. Never place your body on the kickback area;
the kickback will propel the tool to the oppo-
site direction of the rotation abrasive disc.
4. Use extra care when working with edges.
These tend to engage the disc.
5. Don’t use the tool with cutting saws. These
produce kickback.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. SWITCH WITH LOCK-ON BUTTON
2. ANTI-VIBRATION HANDLE SIDE
3. DISK COVER
4. SPINDLE LOCK BUTTON
ASSEMBLY INSTRUCTIONS
WARNING: Remove the grinder from the
carton and examine it carefully. Do not discard
the carton or any packaging material until all
parts are examined.
LATERAL HANDLE
The lateral handle
must be used always
that the machine is
running.
Screw the lateral handle inside the holes, could
be on the right or left side. Your choice is de-
termined by your convenience and ability to
keep the complete control.
GUARD
The guard is a security device to prevent
injuries caused by pieces of abrasive disc.
1. Disconnect the plug
from the electrical
outlet.
2. Loosen the clamp
screws.
3. Position the guard
at the required angle.
4. Tighten the clamp screws.
INSTALL AND REMOVE THE ABRASIVE DISC
To Install:
1. Disconnect the plug from the electrical out-
let. Make sure that the guard is securely in
place.
2. Remove the outer flange.
3. Check that the inner
flange is properly seated
on the spindle. It will click
into place on the spindle,
and will cause the spindle
to rotate when the inner
flange is rotated.
1
2
5
3
4
EA204 manual.indd 11
24/06/15 16:47
