42
Troubleshooting
If a fault occurs, first refer to this information before you take the device for repair.
If you are unable to rectify the fault using the information given here, contact your local deal-
er or service specialist.
Under no circumstances should you attempt to repair the radio recorder yourself, as this
would invalidate the guarantee.
INFORMATION
_______________________________________________
PROBLEM
GENERAL
INFORMATION
No sound
The device does not
respond to button com-
mands.
RADIO
Poor radio reception
CD
Playback will not start
The CD player skips tracks
CD-Rs or CD-RWs are
not being played back,
or being played back
incorrectly
TAPE
Poor cassette playback
sound quality
No cassette recording
POSSIBLE CAUSE
The volume setting is too low
The headphones are connected
The batteries are flat
The batteries are incorrectly inserted
The mains cable is incorrectly
connected
Static electrical discharge
Weak radio antenna signal
Interference from electrical devices
such as televisions, video recorders,
computers, neon lamps etc.
The CD is damaged or dirty
A stored track memory is being
played
The RANDOM function is activated
The CD is faulty or the software or
hardware settings were incorrect
during burning
Dust and dirt on magnetic heads,
capstans or idlers
Recording protection tab
has been broken off
REMEDY
Adjust the volume, unplug the
headphones
Replace the batteries, insert then
correctly
Connect the mains cable properly
Switch off the device, disconnect the
mains cable
and plug it in again after a few
seconds
Remove any batteries
VHF (FM): tilt and turn thetelescopic
antenna, switch to mono reception
MW: turn whole device
Keep radio recorder away from
electrical devices
Replace or clean the CD
Switch to normal playback or delete
Switch off the RANDOM function
Check the components of your CD
burner / burner software or change
the CD you are using
Clean the magnetic heads, capstan
and idler
Cover the opening with adhesive
tape
