Grundig GWN39430W, Руководство пользователя

Страница: 14 / 44

Electrical requirements
Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket in a
readily accessible position.
Should the mains lead of the appliance
become damaged or need replacing
at any time, it must be replaced by
a special purpose made mains lead
which can only be obtained from a
Authorised Service Agent.
B
WARNING:
This appliance must
be earthed.
If the fitted moulded plug is not
suitable for your socket, then the plug
should be cut off and an appropriate
plug fitted.
Destroy the old plug, which is cut off as
a plug with a bared cord could cause a
shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the
fuse need to be replaced an ASTA
approved BS1362 fuse of the same
rating must be used. Do not forget
to refit the fuse cover. In the event of
losing the fuse cover, the plug must
not be used until a replacement fuse
cover has been fitted. Colour of the
replacement fuse cover must be the
same colour as that visible on the
pin face of the plug. Fuse covers are
available from any good electrical
store.
Important
Fitting a different plug
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals on
your plug, proceed as follows:
1 Connect the green - yellow or
green (earth) wire to the terminal in
the plug marked ‘E’ or with the symbol
f or coloured green and yellow or
green.
2 Connect the blue (neutral) wire to
the terminal in the plug marked ‘N’ or
coloured black.
3 Connect the brown (live) wire to
the terminal in the plug marked ‘L’ or
coloured red.
With the alternative plugs a 13A fuse
must be fitted either in the plug or
adaptor or in the main fuse box. If in
doubt contact a qualified electrician.
Transportation of the product
• Unplug the product before
transporting it.
• Remove water drain and water
supply connections.
• Drain all water that has remained
in the product.
• Install transportation safety bolts
in the reverse order of removal
procedure; .
C
Never move the product without
the transportation safety bolts
properly fixed in place!
A
WARNING:
Packaging materials
are dangerous to children. Keep
packaging materials in a safe
place away from reach of the
children.
14