Grundig GWN38430W, Руководство пользователя

Страница: 12 / 48

Installation
To make the product ready for use,
review the information in the user
manual and make sure that the
electricity, tap water supply and water
drainage systems are appropriate. If
they are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C
Preparation of the location and
electrical, tap water and waste
water installations at the place of
installation is under customer's
responsibility.
B
WARNING:
Installation and
electrical connections of the
product must be carried out by
competent persons. Manufacturer
shall not be held liable for
damages that may arise from
procedures carried out by
unauthorized persons.
A
WARNING:
Prior to installation,
visually check if the product has
any defects on it. If so, do not have
it installed. Damaged products
cause risks for your safety.
C
Make sure that the water inlet
and discharge hoses as well as
the power cable are not folded,
pinched or crushed while pushing
the product into its place after
installation or cleaning procedures.
Appropriate installation location
• Place the machine on a rigid floor.
Do not place it on a long pile rug
or similar surfaces.
• Total weight of the washing
machine and the dryer -with full
load- when they are placed on top
of each other reaches to approx.
180 kilograms. Place the product
on a solid and flat floor that has
sufficient load carrying capacity!
• Do not place the product on the
power cable.
• Do not install the product at
places where temperature may
fall below 0ºC.
• Leaving a gap at the sides of the
machine is suggested to reduce
vibration and noise
• Do not place heat sources such
as Hobs, Irons, Ovens, etc. on the
washing machine and do not use
them on the product.
Removing packaging reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove
the packaging reinforcement by pulling
the ribbon.
Removing the transportation locks
A
WARNING:
Do not remove the
transportation locks before taking
out the packaging reinforcement.
A
WARNING:
Remove the
transportation safety bolts before
operating the washing machine!
Otherwise, the product will be
damaged.
• Loosen all the bolts with a
suitable spanner until they rotate
freely.
12