•
Remove transportation safety
bolts by turning them gently.
•
Attach the plastic covers supplied
in the User Manual bag into the
holes on the rear panel.
C
Keep the transportation safety
bolts in a safe place to reuse when
the washing machine needs to be
moved again in the future.
Never move the product without the
transportation safety bolts properly
fixed in place!
Connecting water supply
C
The water supply pressure required
to run the product is between 1 to 10
bars (0.1 – 1 MPa). It is necessary to
have 10 – 80 liters of water flowing
from the fully open tap in one minute
to have your machine run smoothly.
Attach a pressure reducing valve if
water pressure is higher.
A
WARNING:
Models with a single
water inlet should not be connected
to the hot water tap. In such a case
the laundry will get damaged or the
product will switch to protection
mode and will not operate.
A
WARNING:
Do not use old or
used water inlet hoses on the new
product. It may cause stains on your
laundry.
•
Tighten all hose nuts by hand.
Never use a tool when tightening
the nuts.
•
Open the taps completely after
making the hose connection
to check for water leaks at the
connection points. If any leaks
occur, turn off the tap and
remove the nut. Retighten the nut
carefully after checking the seal.
To prevent water leakages and
damages caused by them, keep
the taps closed when the machine
is not in use.
Connecting to the drain
•
The end of the drain hose must
be directly connected to the
wastewater drain or to the
washbasin.
A
WARNING:
Your house will be
flooded if the hose comes out of its
housing during water discharge.
Moreover, there is risk of scalding
due to high washing temperatures!
To prevent such situations and to
ensure smooth water intake and
discharge of the machine, fix the
end of the discharge hose tightly so
that it cannot come out.
•
The hose should be attached to a
height of at least 40 cm, and 100
cm at most.
13
EN
