Grundig GRA-D1104B, Руководство пользователя

Страница: 9 / 136

The remote control will only be active if the remote control ID matches with that speci fi ed on the DVR.
If multiple DVRs are installed on one place and you have just a single remote control, use the ID button to set the
remote control ID. Only the ID-matching DVR can be controlled.
1. Under <SYSTEM> - <CONTROL DEVICE> in the System Setup menu, set the <REMOTE CONTROLLER ID> and
press <APPLY>. Select between 00 and 99. For more details, please refer to <SYSTEM SETUP>. The remote
control will be active only if the remote control ID matches the system ID of the DVR.
2. Press the [ID] button on the remote control. The default remote control ID is 00.
3. Use the number buttons to provide a two-digit ID. If you want to enter 01, for instance, enter the number 0 and
1 in sequence. Check if the remote control ID is set properly by manipulating the remote control.
4. To reset the ID to 00, press and hold the [ID] button.
4.2. HDD Specifications & Replacement
Specifications of compatible HDDs:
Maximum SATA Speed:
- SATA1(1.5G) : Can be used
- SATA2(3.0G) : Can be used
- SATA3(6.0G) : Devices of backward compatibility to SATA2 (3.0G) can be used.
Maximum Start-up Current: 12V, 2A (or lower)
Maximum Average Operation Power Consumption: 7W (or lower)
Maximum R/W Latency: Latency (Read: 13ms / Write: 13ms) or smaller
ATTENTION:
- Use 3.5” HDD disks.
- Using HDD devices other than described in the recommended specifications above may cause serious
problems.
- For further information about the HDD specifications, refer to the applicable data sheet of the HDD
manufacturer.
The users can replace the hard disk if the existing one reaches its full capacity or becomes problematic.
HDD Installation and Replacement Procedure:
1. Remove the screw from the bracket on the bottom side of the DVR.
7 English