- Upload Image by E-Mail:
After selecting this item, the Administrator can assign an e-mail address and configure various parameters as
shown in the picture below. When a motion is detected, event images will be sent to the appointed e-mail address.
The <Pre-trigger buffer> recording function allows users to check what happened to trigger the alarm. The pre-
trigger buffer time range is from 1 to 20 frames.
On the other hand, the <Post-trigger buffer> is for uploading a certain amount of images after the alarm input is
triggered. The post-trigger buffer time range is from 1 to 20 frames.
Check the box <Continue image upload> to upload the triggered images during a certain time or keep uploading
until the trigger is off.
- Select <Upload for __sec> and enter the duration in the blank. The images of the duration will be uploaded via
E-Mail when the alarm input is triggered. The setting range is from 1 to 9999 seconds.
- Select <Upload while trigger is active> to keep the images being uploaded via E-Mail while the trigger is active,
i.e. until the alarm is stopped.
Set the Image frequency as the upload frame rate. The setting range is from 1 frame to 15 frames.
NOTE: Normally, the setting range of the <Pre-trigger buffer> is 1 to 20. However, the setting range will change
accordingly if the frame rate of MJPEG on the <Video Frame Rate> setting page is 6 or smaller.
NOTE: Normally, the setting range of the <Pre-trigger buffer> is 1 to 20. However, the setting range will change
accordingly if the frame rate of MJPEG on the <Video Frame Rate> setting page is 6 or smaller.
NOTE: Make sure SMTP and/or FTP configuration has been completed. See section 9.5. Mail and 9.6. FTP for
further details.
- Send HTTP notification:
Check this item, select the destination HTTP address, and specify the parameters for event notifications when
<Motion Detection> is triggered. When an alarm is triggered, the notification can be sent to the specified HTTP
server.
For instance, if the custom parameter is set as ”action=1&group=2”, and the HTTP server’s name is
”http://192.168.1.200/admin.php”, the notification will be sent to the HTTP server as
”http://192.168.1.200/admin.php? Action=1&group=2” when an alarm is triggered.
File Name :
The uploaded image’s filename format can be set in this section. Please select the one that meets your
requirements (please see the section "File Name" in 9.8.1. 'Application (Alarm Settings)').
Save :
Click on the "Save" button to save all the Motion Detection alarm settings mentioned above.
45
English
