Grundig GCA-C0245P, Руководство пользователя

Страница: 35 / 46

DETECT SWITCH:
This item is used to enable or disable the ALARM DETECT function.
DETECT MODE:
The Motion Mode is set in this section.
- MOTION:
The Motion Detection function allows detecting suspicious motion and triggers alarms when the motion volume in
the detected area reaches/exceeds the determined sensitivity threshold value. The main menu is shown below:
BLOCK MODE:
In Motion Detect Mode, users can set Block Mode to “ON” or “OFF”. When BLOCK MODE is turned on and there
are any variations (e.g. caused by intrusion in the observed area) in the sections of the monitoring image, the
affected parts will be highlighted dynamically.
FRAME SET:
In a monitored field, users can define specific areas as motion detection target zones. Please refer to the
following instructions to configure the parameters for each motion detection zone, the so-called “Frames”. When
motion is detected within a defined frame, the flash warning notice "MOTION" will be displayed in the upper left
corner of the screen.
In total, four frames can be set. Select a frame using the right/left keys on the keyboard, and press “ENTER” key
to enter the frame’s submenu, as shown below.
- LEFT LIMIT:
Move the frame right/left using the right/left keys on the keyboard.
- TOP LIMIT:
Shift the frame up/down using the right/left keys on the keyboard.
- H/V SIZE:
Adjust the frame size via changing the H/V size value using the right/left keys on the keyboard.
- MODE:
Assign a trigger action to a specific motion detection frame. The options include PRESET, SEQUENCE, AUTOPAN
and CRUISE. When motion is detected within a frame, the Dome Camera will execute the specific trigger action.
33 English