Grundig 40 VLE 565 BG, Инструкция пользователя

Страница: 54 / 60

ENGLISH
­54
SPECIAL­SETTINGS
­----------------------------------------------------------------------------------------------------------
Searching­for­digital­terrestrial­
TV­channels­manually
1 Open the menu with » MENU «.
2
Select the menu item »SOURCE SETUP« with
»
V
« or »
Λ
« and press »
OK
« to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
V
« or »
Λ
«
and press » OK « to confirm.
Select the option »Air« with »
<
«, »
>
«, »
V
« or
»
Λ
« and press » OK « to confirm.
Caution:
7
The antenna power supply (line »Active
Antenna Power«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
supplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4
Select the »Active Antenna Power«« with
»
V
« or »
Λ
«. Switch on the antenna pow-
er supply for the antenna with »
<
« or »
>
«
(»On«).
5 Select » Digital Manual Tuning« with »
V
« or
»
Λ
« and press » OK « to confirm.
– The menu appears.
6 Enter the channel number directly with
»
1­...­0
«.
– After the search is complete, the channels
found are displayed in the »Results« menu.
7
Press »
EXIT
« to finish the setting.
Tuning­analogue­television­
­channels
This setting is only necessary if you cannot re-
ceive any digital channels and you have not car-
ried out an analogue search during initial setup.
The television channels can be set directly or
using the scan.
Switching­the­television­to­
­analogue­reception
Note:
7
Analogue channels can be selected if the
option »Air« or »Cable« has been selected.
1 Open the »Select input source« menu with
» «.
2
Depending on the antenna system, select the
option »Air« or »Cable« with »
V
«, »
Λ
«, »
<
«
or »
>
« as the input source and press »
OK
«
to confirm.
Note:
7
Additional operations are explained in the
following sections.
Setting­all­analogue­television­
channels
Analogue channels are displayed in the channel
list after the digital channels.
Note:
7
Plug the rooftop antenna cable (for analogue
television channels) into the » ANT­IN «
socket on the television.
1
Open the menu with »
MENU
«.
2 Select the menu item »SOURCE SETUP« with
»
V
« or »
Λ
« and press » OK « to confirm.
– The »SOURCE SETUP« menu appears.
3
Select the line »Source« with »
V
« or »
Λ
«
and press »
OK
« to confirm.
Select the option »Air« or »Cable« with »
<
«,
»
>
«, »
V
« or »
Λ
« and press »
OK
« to con-
firm.