Grundig 32 VLC 9140 S, Руководство пользователя

Страница: 56 / 63

ENGLISH
­56
speCiAl­settinGs
­----------------------------------------------------------------------------------------------------------
»PROGRAM TABLE« appears.
note:
7
You can abort the search by pressing
» menu «.
9 Press » menu « to end the setting.
searching­for­digital­terrestrial­
tv­channels­manually
1
Open the menu with »
menu
«.
2 Select the line »SOURCE SETUP« with »
v
«
or »
Λ
« and press » oK « to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
v
« or »
Λ
«
and press » oK « to confirm.
Select the option »Air« with »
<
«, »
>
«, »
v
« or
»
Λ
« and press »
oK
« to confirm.
Caution:
7
The antenna power supply (line »Active
Antenna Power«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
supplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4 Select the »Active Antenna Power«« with »
v
«
or »
Λ
«. Switch on the antenna power supply
for the antenna with »
<
« or »
>
« (»On«).
5 Select » Digital Manual Tuning« with »
v
« or
»
Λ
« and press » oK « to confirm.
– The menu appears.
6 Enter the channel number directly with
»
1­...­0
« and press »
oK
« to confirm.
– After the search is complete, the channels
found are displayed in the »Results« menu.
7 Press » menu « to finish the setting.
tuning­analogue­television­
­channels
This setting is only necessary if you cannot re-
ceive any digital channels and you have not car-
ried out an analogue search during initial setup.
The television channels can be set directly or
using the scan.
switching­the­television­to­
­analogue­reception
note:
7
Analogue channels can be selected if the
option »Air« or »Cable« has been selected.
1 Open the »Select input source« menu with »
«.
2
Depending on the antenna system, select the
option »Air« or »Cable« with »
v
«, »
Λ
«, »
<
«
or »
>
« as the input source and press » oK «
to confirm.
note:
7
Additional operations are explained in the
following sections.
setting­all­analogue­television­
channels
Analogue channels are displayed in the channel
list after the digital channels.
note:
7
Plug the rooftop antenna cable (for analogue
television channels) into the »
Ant­in
«
socket on the television.
1
Open the menu with »
menu
«.
2 Select the line »SOURCE SETUP« with »
v
«
or »
Λ
« and press »
oK
« to confirm.
– The »SOURCE SETUP« menu appears.
3
Select the line »Source« with »
v
« or »
Λ
«
and press »
oK
« to confirm.
Select the option »Air« or »Cable« with »
<
«,
»
>
«, »
v
« or »
Λ
« and press »
oK
« to con-
firm.
4
Select the line »Automatic Channel Search«
with »
v
« or »
Λ
« and press »
oK
« to con-
firm.