3. Installing the product
3.1 Installing the controller
3.1.1 Location
Install the product in a location that meets the following requirements:
•
Place the product in a flood-safe place.
•
Make sure that the ambient temperature is within the limits.
•
Install the product as close as possible to the lifting station.
•
If you install the product outdoors, place it in a protective shed or enclosure, class IP55.
•
Do not expose the product to direct sunlight.
Related information
3.1.2 Mechanical installation
CAUTION
Back injury
Minor or moderate personal injury
● Use lifting equipment.
CAUTION
Crushing of feet
Minor or moderate personal injury
● Wear safety shoes when moving the product.
3.1.2.1 Installing the controller
You can install the controller without removing the front cover.
1. Mark up the holes on a plane wall.
2. Drill the holes.
3. Remove the plastic caps that cover the screw holes in the controller or open the control cab-
inet.
4. Install the controller with the cable entries pointing downwards.
If required, fit additional cable entries in the bottom plate of the control cabinet.
5. Fit the screws.
6. Fit the plastic caps, if any.
3.1.3 Electrical connection
DANGER
Electric shock
Death or serious personal injury
● Switch off the power supply before you start any work on the product. Make
sure that the power supply cannot be accidentally switched on.
Multilift MD1, MDV | |
8
