Grundfos MAGNA 32-100, Инструкция по эксплуатации

Страница: 10 / 24

10
(
Q
J
OLV
K
8
6
8.10 Expansion modules
The pump can be fitted with an expansion module
enabling communication with external signals
(signal transmitters).
Two types of expansion modules are available:
• Relay module
• GENI module.
8.10.1 Relay module
For mounting and operation, see relay module
installation and operating instructions.
Functions
• External start/stop
• Fault, ready and operating indication via signal
relay.
8.10.2 GENI module
For mounting and operation, see GENI module
installation and operating instructions.
Functions
• External start/stop
• External forced control
• External analog 0-10 V control
• Bus communication via GENIbus
• Duty standby alternating mode
• Fault, ready and operating indication via signal
relay.
8.11 Connection to LON network
The pump can be connected to a LON network via a
GENI module and an external Grundfos G10 LON
interface. Product number: 605726.
Fig. 10 Connection to LON network
9. Pump setup
For the setting of the pump, use:
• control panel.
• R100 remote control.
• bus communication (not described in detail in
these instructions, contact Grundfos).
The table shows the application of the individual
operating units and in which section the function has
been described.
"–" = not available with this operating unit.
9.1 Factory setting
The pump is factory-set to AUTO
ADAPT
without
automatic nighttime duty.
TM
03
03
78
50
04
LON network
24 VAC/VDC
GENI module
Possible settings
Co
nt
ro
l
pa
n
e
l
R1
0
0
AUTO
ADAPT
9.2.1 9.7.1
Automatic nighttime duty 9.2.1 9.7.2
Proportional-pressure
control
9.2.1 9.7.1
Constant-pressure con-
trol
9.2.1 9.7.1
Setpoint setting 9.2.2 9.5.1
Max. curve duty 9.2.3 9.5.2
Min. curve duty 9.2.4 9.5.2
Constant-curve duty – 9.5.2
Temperature influence – 9.7.3
Activation/deactivation of
pump buttons
– 9.7.4
Allocation of pump num-
ber
– 9.7.6
Start/stop 9.2.5 9.5.2
Resetting of fault indi-
cations
9.2.6 9.5.3
Reading of various data –
9.6.1 -
9.6.7