Grundfos G 401, Инструкция по установке и эксплуатации

Страница: 6 / 23

6
CONTENTS
Page
1. General description 6
2. Applications 6
2.1 G 401 and G 402 6
2.2 G 403 6
2.3 G 404 and G 405 6
2.4 G 406 6
3. G 400 module 7
4. Mounting 8
5. Indicator lights (LEDs) 9
6. Ethernet 10
6.1 IP address 10
7. USB 10
7.1 Updating of firmware 11
8. GSM modem 11
8.1 G 401 11
8.2 G 402 11
8.3 G 404 11
8.4 G 405 11
8.5 GSM antenna 11
8.6 SIM card 11
9. RS-232 port 14
9.1 G 403 14
9.2 G 406 14
10. GENIbus 14
11. Connection 14
11.1 Power supply 14
12. Technical data 15
13. Replacement of G 400 16
14. Maintenance 17
15. Dimensions 17
16. Disposal 17
1. General description
The G 400 range of modules incorporates both a
gateway between various ports, protocols and
modem functions.
The G 400 range consists of the G 401, G 402,
G 403, G 404, G 405 and G 406 modules.
G 400 refers to the whole range of modules.
2. Applications
2.1 G 401 and G 402
GSM modem via Ethernet
The G 401 and G 402 are connected to a CU 401
control unit via an Ethernet cable. See cable specifi-
cation in section
12. Technical data .
The modem can function as a GSM modem, a GPRS
modem and send/receive SMS messages. The
actual function is determined by the application on
the CU 401.
For GSM data communication with e.g. a SCADA
system, both the COMLI and ModBus protocols can
be used. The application determines which protocol
to use in the actual situation.
2.2 G 403
Radio modem via Ethernet
The G 403 is connected to a CU 401 control unit via
an Ethernet cable. See cable specification in section
12. Technical data .
The modem is connected to the RS-232 port via a
cable. The actual function is determined by the appli-
cation on the CU 401.
For GSM data communication with e.g. a SCADA
system, both the COMLI and ModBus protocols can
be used. The application determines which protocol
to use in the actual situation.
2.3 G 404 and G 405
GSM modem via GENIbus
The G 404 and G 405 can be connected to a GENI-
bus network to communicate via a GSM modem.
The modem can function as a GSM modem, a GPRS
modem and send/receive SMS messages. The
actual function is determined by the application on
the G 404 or G 405.
For GSM data communication with e.g. a SCADA
system, both the COMLI and ModBus protocols can
be used. The application determines which protocol
to use in the actual situation.
2.4 G 406
Radio modem via GENIbus
The G 406 can be connected to a GENIbus network
to communicate via a radio modem.
The radio modem is controlled via an RS-232 port.
Prior to installation, read these installation
and operating instructions. Installation and
operation must comply with local regula-
tions and accepted codes of good prac-
tice.
All wires to units outside the control panel
must be of the type H05VV-F according to
CENELEC HD21 (to avoid injury from
touching wires).