5
1. Loosen three Screws
(24) with a slotted head
screwdriver.
2. Remove Switch Cover
(23)
& disconnect the couplers
attached to it. Also remove
Rubber Washer (21) &
Rubber Grommet (20).
3. Grab the locking clips of
Rocker Switch (25) & press
from inside to remove the
switch.
4. Loosen Motor Bolts (22)
with 8 mm wrench.
5. Remove Brush Cover (19).
MOTOR KIT REPLACEMENT (Refer to EXPLODED VIEW - Page 6)
6. Remove four Allen Bolts
(1) using Allen Key (size 4).
Remove Cover Plate (2),
Vanes (4), Rotor (6) & Key
(5) from Housing (12).
7. Pull the Magnet Assembly
(14) & disconnect Armature
Assembly (15) from
Housing (12).
Thermostat
Carbon Brush
8. Replace Motor kit (
EDP/KIT/MK
) in reverse order ensuring the
following points:
•
CORRECT ORIENTATION OF VANES
as shown in Step 2
of section
VANE REPLACEMENT
.
•
CORRECT FITTING OF CARBON BRUSHES:
Align the teeth on Brush Cover (19) with the notch on
Magnet Assembly (14).
Cover Teeth
Notch
