Grove toucan 1010, Руководство по обслуживанию

Страница: 30 / 73

Toucan 1010
Models
Revision 02-2000
30
DEFAULT LED CURRENT LEDs INDICATOR
The first LED flashes
Voltage still below 1,7 V per cell after 1 minute of
charge
The 2nd LED flashes
Voltage still below 2,05 V per cell after 1 hour of
charge
The 3rd LED flashes
Voltage per cell still below the required gazing
voltage after 10 hours of charge.
The 4th LED flashes
Charging safety time exceeded.
Default LED flashes
Charge interruption due to a power cut. Charge
will be resumed as soon as the power returns.
The 4 LEDs flash
Voltage per cell 140% above the nominal values.
SIGNALLING
CAUSE
Default LED lights up
4.2.2 "Oldham-Hawker" charger
Power supply : 110VAC - 60Hz / 230VAC - 50Hz
- Adaptation to network voltage :
Prior to any operation requiring charger
cover removal, the battery must be
disconnected and the charger must be
unplugged from the AC outlet. Failure to do
so could result in death or serious injury to
personnel.
Connections on transformer inlet terminals block :
- Protections :
- Single pole circuit breaker : 32 Amps.
- Output fuse : 100 Amps.
FAULT SIGNALLING CHART (CPIV models)
?
?
NOTE
A spare output fuse is strapped inside the
charger cover.
- CP IV models
CP IV models panel
a. Charger ON LED indicator (green).
b. Second charging rate LED indicator (yellow).
c. End of charge LED indicator (green).
d. Ah applied into the battery : 4 LEDs (from the right
to the left : 100% - 75% - 50% - 25%).
e. ON/OFF switch.
f. Default led indicator (red).
g. Circuit breaker.
230 VAC - 50 Hz 110 VAC - 60 Hz
Jumpers
brow
n
blue
brow
n
blue
DANGER
a
f
b
e
c
g
a
BATTERY - CHARGER 4 4