MCD-VOYAGER User Manual
Ground Control
LAN PORT 1 – RJ-45 port for Ethernet connection. It is sealed covered
with a quick-disconnect water cap. This Ethernet port is PoE capable
(Power Over Ethernet). Optional accessory cable adapters are
available to keep a watertight seal for Ethernet cables.
LAN PORT 2 – The MCD-Voyager front panel has a 2
nd
RJ-45 port for
Ethernet connection that is also PoE capable. (Both PoE Ethernets
ports are rated PoE-IEEE 802.3af standard).
Light Sensor – This sensor will backlight the display in darkness so the display
can be read. From the MCD-VOYAGER control panel, the sensitivity of this
sensor can be set, including always off.
Display – Shows power up status and battery level.
Charge / Power Port – This port is used to connect the Power
Supply. The supply will power, recharge and maintain the MCD-
VOYAGER. Charging is automatic and based on the state of the
batteries. The charge system will work as necessary with the unit on
or off. Higher outside air temperatures may increase charge time if
the unit is on while charging. Always install the Port Cap when
Power Supply is not connected to maintain its weatherproof
integrity.
6
