46
46
of the cover.
Remove both plastic covers.
STEP 5
– Find the covered circuit board on
one side of the MAGELLAN.
STEP 6
– Locate the holes on the circuit
board for you fingers. Pressing on one will
raise elevation, pressing on the other will
lower elevation.
MANUAL STOW #3 –
Remove the Elevation Motor, which will allow the
Elevation gear to move freely.
MANUAL STOW PROCESS 4
– The worst of all scenarios is actually removing
the MAGELLAN. There are only 6 nuts that hold the MAGELLAN to the mounting
plate. Unscrew these nuts and the entire dish may move freely on the roof. You may
strap it down on the roof. It is not recommended that you cut the wire. Re-wiring a cut
wire is not covered by the warranty.
