Grohe Blue Pure 31087, Руководство по установке

Страница: 6 / 9

3
Warning
Risk of damage:
Always disconnect the power supply before performing
maintenance work on the system. The plug-in connectors
can then be disconnected
, see fold-out page II, Fig. [8].
Inspect and clean all components and replace if necessary.
I. Cartridge,
see fold-out page II, Fig [11].
Assemble in reverse order. When installing the cartridge,
ensure that the seals are correctly seated. Replace screw
coupling and tighten.
II. Headpart,
see fold-out page II, Fig. [12].
Assemble in reverse order. Note the installation position of the
stop.
III. Mousseur (64 374),
see fold-out page I.
Assemble in reverse order.
Service
Note the
Fault / Cause / Remedy
table for information on
eliminating problems.
If EE flashes or the problem cannot be rectified, interrupt the
power supply and consult a specialist installer or contact the
GROHE Service Hotline via email under
TechnicalSupport-
HQ@grohe.com
.
Replacement parts
See fold-out page I (* = special accessories).
Care
For directions on the care of this fitting, please refer to the
accompanying Care Instructions.
Environment and recycling
Used filter cartridges can be disposed of hazard-free in
domestic waste.
Fault Cause Remedy
Water not flowing
• Water supply interrupted - Open shut-off valves
Filtered water not
flowing
• Water supply interrupted - Establish water supply to fitting
No filtered water, E3
in the display
• No connection between fitting and
cooler/carbonator
• Cable or connector faulty
- Connect plug-in connector
- Contact GROHE Service
No filtered water,
Blue
®
handle flashes
red, E4 in the display
• Fitting and control unit not synchronized - Synchronise with one another, see section
Installation
No filtered water,
Blue
®
handle flashes
red, E6 in the display
• Values range does not concur - Synchronise with one another, see section
Installation
Blue
®
handle flashes
orange, E7, E8 in the
display
• Filter capacity exceeded - Change filter cartridge immediately
Indicator lamps
do not flash/flash
continuously
• Control not recognised - With mains plug connected, disconnect plug-in
connector, wait 30 seconds and reconnect
Display in handle
does not illuminate
or illuminates
continuously
• No connection between fitting
and control unit
- Synchronise with one another, see section
Installation
www.divapor.com