Grohe 45 440, Руководство пользователя

Страница: 11 / 114

8
Registering Controllers to a Base Unit
Main Controller, Remote Controller and Base Unit are supplied
as a set and are already configured to communicate with each
other.
The controllers should not be positioned at more
than 10 metres from the Base Unit.
Up to eight controllers in total can be registered to a Base Unit.
This allows system expansion.
If additional or replacement controllers need to be added,
there are several methods of registration depending on the
situation. In all cases, the Base Unit must be connected to the
mains electricity supply, the shower must be off and controllers
must be fitted with batteries.
Case 1 - Adding a Main Controller when an already registered
Remote Controller is available.
1. Press the three memory buttons on the Remote Controller
simultaneously for 5 seconds.
2. Enter SETUP mode on the new Main Controller, select
REGISTR and press the Pause button. A tone will sound to
signify that the Main Controller has been registered.
Case 2 - Adding a Remote Controller when an already
registered Main Controller is available.
1. Enter SETUP mode on the Main Controller, select REGISTR
and press the Pause button.
2. Press the three memory buttons on the new Remote
Controller simultaneously for 5 seconds.
Case 3 - Adding a Main or Remote Controller when no other
registered controller is available.
1. Remove the DATA Hatch from the Base Unit and press the
reset button.
2. To register a Main Controller, enter SETUP mode on the
new Main Controller, select REGISTR and press the Pause
button. A tone will sound to indicate that the Main controller
has been registered.
3. To register a Remote Controller, press the three memory
buttons on the Remote Controller simultaneously
for 5 seconds.
The System will wait in REGISTR mode for 2 minutes and then
automatically exit the mode if no attempt is made to register
a controller.
In all registration cases, the system will carry out a calibration
which takes approximately 1 minute after registration is
complete and WAIT will be displayed if an attempt is made
to use the shower.
Cleaning
To clean the controllers without unintentionally starting the
shower, press and hold the
Pause button for 5 seconds when
the shower is off. This will render all buttons inoperative for
a period of 5 minutes and CLEANUP is displayed.
This mode can be cancelled by pressing the
Pause button
again for 5 seconds.
Care
For directions on care, refer to the accompanying Care
Instructions.
Fault Cause Remedy
Main Controller:
Battery symbol flashes and tone
sounds
Remote Controller:
ON / OFF button flashes
every 30 seconds • Batteries almost depleted - Replace batteries
Service 01 displayed on Main
Controller or three buttons lit
on Remote Controller • No wireless communication - Check that power is supplied to the
Base Unit
- Verify that controller is within 10 m
of Base Unit
Other service numbers displayed
on Main Controller • Internal fault - Contact a service engineer if the
service code persists