Groen SSB-10GF, Руководство оператора, Страница: 12 / 20

1
om-ssb-3g/5g/10gf
Warning! alloW tHe steamer to cool
completelY before cleaning. Hot
surfaces can cause seVere burns.
recommenDeD tools & cleaners:
- Nylon scrub pad, clot or sponge. Scotch-Brite™
Medium duty scrubbing sponges are preferred. Do
not use metal scrub pads.
- Mild detergent soap.
cleaning steps:
step 1 - p ress ON/OFF touch pad to turn steamer
OFF and open steamer door.
step 2 - CAUTION: allow the steamer to cool
completely before cleaning
step 3 - remove steam lid by grasping the two tabs
located on the lid front and sliding pan forward.
step 4 - remove left pan rack by lifting rack up and
pulling away from cavity wall.
step 5 - remove right fan shroud and rack assembly
by lifting rack up and pulling away from cavity wall.
STEP 6 - Clean steam lid, left pan rack and rack/
shroud assembly to remove food soils. These three
parts may be cleaned in a dishwasher.
step 7 - Uses a mild detergent to wipe down the entire
steamer cavity to remove food and scale particles.
Carefully clean float probes if food residue or loose
scale is present. A thin layer of tightly bound scale
is normal and will not affect steamer performance. If
scale is excessive, then refer to deliming instructions
below.
STEP 8 - replace pan racks and steam lid. Steamer
is now cleaned and ready to use.
Deliming instructions:
•
When using Groen Boilerless Water Filtration
System use vinegar as a deliming agent.
•
Groen approved delimer may be used to
remove excessive scale build-up.
step 1 - After following all cleaning steps 1 through
7 listed above, turn steamer on and allow water to
enter steamer cavity.
step 2 - Pour 1 cup of vinegar or delimer into
steamer cavity and shut door.
step 3 - Set steamer timer to 0 minutes and allow
steam cleaning to occur.
step 4 - After 0 minute cleaning cycle is complete,
turn steamer OFF and allow to cool completely.
step 5 - Open steamer door and wipe down the
entire steamer cavity to remove loosened scale
particles. Carefully clean float probes if loose scale
is present.
STEP 6 - replace pan racks and steam lid. Steamer
is now cleaned and ready to use.
failure to clean tHe steamer as
specifieD coulD negatiVelY impact
tHe performance of tHe steamer.