Groen DEE/4 Series, Руководство оператора

Страница: 9 / 24

OM-DEE/4
9
Operation
The operator controls kettle heating with the
thermostat dial. The dial turns heating element
power on or off and sets the kettle operating
temperature.
A. To Start Kettle
1. EVERY DAY make sure that the jacket
water level is between the marks on the
gauge glass. If the level is too low, see
“Jacket Filling and Water Treatment” on
page 13.
2. Check the pressure gauge. If the gauge
does not show 20 to 30 inches of
vacuum (that is, a reading of 20 to 30
below 0), see “Jacket Vacuum” on page
13.
3. Turn on the electrical power to the unit.
4. Turn the thermostat dial to the desired
setting. The heating indicator light
indicates that the kettle is heating.
Cycling of the light on and off shows that
the kettle is being held at the set
temperature.
Once in each cycle the
contactors in the support housing will
make a clicking sound. This is
normal.
B. To Transfer Product or Empty Kettle :
1. The kettle is tilted by means of the crank
on the front of the control housing. The
kettle remains in the position to which
tilted until cranked again.
2. Product may also be transfered by
means of the optional draw-off valve if
the kettle is so equipped.
WARNING
AVOID ALL DIRECT CONTACT WITH HOT
SURFACES. DIRECT SKIN CONTACT
COULD RESULT IN SEVERE BURNS.
AVOID ALL DIRECT CONTACT WITH HOT
FOOD OR WATER IN THE KETTLE. DIRECT
CONTACT COULD RESULT IN SEVERE
BURNS.
TAKE SPECIAL CARE TO AVOID CONTACT
WITH HOT KETTLE BODY OR HOT
PRODUCT, WHEN ADDING INGREDIENTS,
STIRRING OR TRANSFERRING PRODUCT
TO ANOTHER CONTAINER.
CAUTION
DO NOT OVERFILL THE KETTLE WHEN
COOKING, HOLDING OR CLEANING. KEEP
LIQUIDS AT LEAST 2-3” (5-8 cm) BELOW
THE KETTLE BODY RIM TO ALLOW
CLEARANCE FOR STIRRING, BOILING
PRODUCT AND SAFE TRANSFER.
WARNING
WHEN TILTING KETTLE FOR PRODUCT
TRANSFER:
1) WEAR PROTECTIVE OVEN MITT AND
PROTECTIVE APRON.
2) USE DEEP CONTAINER TO CONTAIN
AND MINIMIZE PRODUCT SPLASHING.
3) PLACE CONTAINER ON STABLE, FLAT
SURFACE, AS CLOSE TO KETTLE AS
POSSIBLE.
4) STAND TO LEFT OR RIGHT OF KETTLE
WHILE POURING — NOT DIRECTLY IN
POUR PATH OF HOT CONTENTS.
5) P O U R S L O W L Y , M A I N T A I N I N G
CONTROL OF KETTLE AT ALL TIMES,
AND RETURN KETTLE BODY TO
UPRIGHT POSITION AFTER CONTAINER
IS FILLED OR TRANSFER IS COMPLETE.
6) DO NOT OVERFILL CONTAINER. AVOID
DIRECT SKIN CONTACT WITH HOT
CONTAINER AND ITS CONTENTS.
Thermostat Dial
Indicator Light
Tilting Crank
9
OM-DEE/4
9