Grizzly T32957, Руководство пользователя

Страница: 27 / 36

Model T32957 (Mfd. Since 09/21)
-25-
Sharpening/
Replacing Blade
The upper blade of the Model T32957 has two
cutting edges so that if one cutting edge becomes
dull, you can reverse the blade and use the fresh,
sharp cutting edge.
Figure 34. Upper blade cap screws and flat
washers.
x 8
Figure 35. Lower blade cap screws and flat
washers.
To sharpen/replace blade:
1. Have another person support blade while you
remove (8) cap screws and flat washers to
remove blade (see
Figures 34–35).
x 8
Items Needed Qty
Another Person .................................................. 1
Protective Gloves (for Each Person) ............1 Pr.
Hex Wrench 8mm .............................................. 1
Surface Grinder ................................................. 1
Mineral Spirits .................................... As Needed
Shop Rags ......................................... As Needed
Metal Protectant ................................ As Needed
New Upper Blade (#PT32957024) ..... As Needed
New Lower Blade (#PT32957025) ..... As Needed
If both of the upper blade cutting edges are dull,
or the cutting edge of the lower blade is dull,
sharpen the blade(s) on a surface grinder and
make sure the blade is flat along the entire length.
Re-sharpen each blade edge as needed until it is
too thin to safely install (as described in the steps
below), then replace the blade. We recommend
you keep an extra set of blades on hand to avoid
any downtime.
2. Reverse blade (upper blade only) or sharpen
on surface grinder.
3. Clean blade with mineral spirits, then apply
thin coat of quality metal protectant.
4. Install blade using hardware removed in
Step 1.
— If blade is so thin after sharpening that
securing cap screws extend beyond oppo-
site side of cutting edge, replace blade.
Shear blades are sharp. Wear protective
gloves when handling blades to prevent
laceration injuries.