No list of safety guidelines can be
complete. Every shop environment
is different. Always consider safety
first, as it applies to your individual
working conditions. Use this and
other machinery with caution and
respect. Failure to do so could result
in serious personal injury, damage
to equipment or poor work results.
Like all machinery there is potential
danger when operating this tool.
Accidents are frequently caused by
lack of familiarity or failure to pay
attention. Use this tool with respect
and caution to decrease the risk of
operator injury. If normal safety pre-
cautions are overlooked or ignored,
serious personal injury may occur.
Model T32540 (Mfd. Since 10/20)
-4
-
Additional Safety for Doweling Jointers
USE RECOMMENDED DRILL BITS. Only
use drill bits rated for speeds greater than
17,000 RPM. Bits not rated for this speed
may fly apart.
Only use drill bits that meet
the specifications listed in the manual. DO
NOT use drill bits with different diameters
or irregular shank shapes/sizes. They will
rotate irregularly, causing ejection of drill
bit fragments and tool damage.
INSPECTING BIT/CUTTING TOOL.
Always inspect bits/cutting tools for sharp-
ness, chips, or cracks before each use.
Replace dull, chipped, or cracked bits/
cutting tools immediately.
PROPERLY INSTALL COMPONENTS.
Ensure sliding base, tool face, and fence
are in place and operating correctly before
each operation.
STARTING AND STOPPING TOOL.
Allow drill bits to reach full speed before
drilling. Always allow drill bits to come to
a complete stop before setting tool down.
MAINTAIN CONTROL OF TOOL. Hold
tool with both hands and DO NOT allow
the doweling jointer base to shift while
performing operations.
Serious cuts, punctures, or death can occur from contact with rotating drill bits
during operation. Workpieces, broken drill bits, or flying particles thrown by
drill bits can blind or strike operators or bystanders with great force. To reduce
the risk of these hazards, operator and bystanders MUST completely heed the
hazards and warnings below.
PROPERLY MAINTAIN DRILL BITS.
Always ensure doweling jointer drill
bits are sharp, undamaged, and tightly
attached before each use.
AVOIDING ENTANGLEMENT. DO NOT
wear loose clothing, gloves, or jewelry.
Tie back long hair. Keep all guards in
place and secure. Always allow spindle
to stop on its own. DO NOT stop spindle
using your hand or any other object.
AVOID TOUCHING DRILL BITS.
Never place hands or fingers between
workpiece and drill bits, and DO NOT
perform operations while supporting
workpiece with one hand or balancing it
on a leg or any other body part.
PROPERLY SUPPORT WORKPIECE.
Properly support all workpieces to
reduce risk of workpiece and tool slip-
ping during drilling operations. Place
workpiece on supports or workbench and
clamp in place.
USE TOOL FOR INTENDED PURPOSE.
Only use jointer on wood and wood-
based products. DO NOT attempt to use
this tool for any other operation.
Содержание T32540
Страница 32: ......
