Grizzly T32540, Руководство пользователя

Страница: 22 / 32

Figure 22. Doweling jointer operation.
Figure 21. Doweling jointer aligned with
workpiece.
Figure 19. Tool positioned perpendicular
to workpiece.
Figure 20. Tool positioned freely on
workpiece.
Model T32540 (Mfd. Since 10/20) -20
-
Drilling Doweling
Holes
The Model T32540 is capable of drilling
holes for
1
⁄
4
"–
7
⁄
16
" dowels.
To drill doweling holes:
1. Place fence on workpiece so viewer
center line is aligned with layout line,
as shown in
Figure 21. Make sure tool
face contacts edge of workpiece.
2. Turn doweling jointer ON and allow
motor to reach full speed.
3. With both hands holding tool, slow-
ly push drill bits into workpiece, as
shown in
Figure 22, making sure
viewer lines are aligned with layout line
on workpiece, as described in
Step 1.
Layout Line
Viewer
Center
Line
Positioning Tool
The doweling jointer should always be
positioned perpendicular to the workpiece
in order to accurately drill joining surfaces
(see
Figure 19).
We recommend using the weight of the
machine to assist with alignment and
guide the direction of operation.
If holes need to be drilled too far from an
edge to use the fence, set the fence angle
to 0º so that the fence and tool face are
flush (see
Figure 20). The doweling jointer
can then be positioned freely.
ALWAYS ensure tool is secure before
starting drilling operations.