Grizzly T32536, Руководство пользователя

Страница: 7 / 44

Model T32536 (Mfd. Since 10/20)
-5-
The following is a list of common definitions, terms and phrases used throughout this manual as they relate
to this lathe and woodworking in general. Become familiar with these terms for assembling, adjusting or
operating this machine. Your safety is
VERY important to us at Grizzly!
Bed: The long, rail-like metal base to which
the tailstock, tool base, and headstock are
attached.
Chuck: A mechanical device that attaches to the
spindle and holds the workpiece.
Faceplate: The metal disc that threads onto the
headstock spindle.
Faceplate Turning: Turning situation in which
the grain of the turning stock is at right angles
to the lathe bed axis.
Backing Block: A sacrificial piece of wood glued
to the base of the workpiece and screwed to
the faceplate. Often used to prevent mount-
ing marks from appearing on the completed
workpiece.
Headstock: The cast metal box to which the
motor is attached and contains the spindle,
bearings, belts, and electrical components for
operating the lathe.
Offset Turning: A turning situation where the
center of the workpiece is offset at various
stages of the work to produce different shapes.
Outboard Turning: Turning of workpiece with
the headstock situated at the far end of the
lathe so the work done is not over the bed of
the lathe.
Roughing Out: Taking stock from square billet
to round blank.
Spindle: This term has two meanings. First, it
refers to the threaded shaft in the headstock
to which the faceplate is attached. Second, it
refers to any work that is spindle-turned.
Spindle-Turning: Work performed where the
grain and length of the workpiece are parallel
to the axis of the bed.
Swing: The capacity of the lathe, measured
by doubling the distance from the bed to the
spindle center.
Tailstock: The metal component at the opposite
end of the bed from the headstock containing a
quill and live or dead centers. It maintains pres-
sure on the spindle-turned workpiece.
Tool Base: The movable metal fixture attached
to the bed upon which the tool rest is fixed.
Tool Rest: The adjustable metal arm upon which
the tool rests during a turning operation.
Way: One of the metal rails that make up the bed
of the lathe.
Glossary of Terms