Grizzly T30945, Руководство пользователя

Страница: 18 / 40

-16-
Model T30945 (Mfd. Since 12/19)
Connecting Power
When connecting the plug to an outlet, ensure the
lowest point of the cord loop is lower than the out-
let the plug is connected to. This helps to ensure
water will "drip" from the cord and not get into the
power receptacle.
Drip Loop
Figure 15.
Connecting to power with a drip loop.
Disconnecting Power
Figure 16.
Disconnecting power.
Turn the machine
OFF. Grasp the plug and pull
it completely out of the receptacle. When discon-
necting the plug from the outlet, ensure the plug,
receptacle, and your hands are dry.
Power Connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connect-
ing or disconnecting the machine from the power
supply.
1. Turn the machine power switch OFF.
2. Grasp the molded plug and pull it completely
out of the receptacle. DO NOT pull by the
cord as this may damage the wires inside.
Bench Mounting
Figure 14. "Direct Mount" setup.
Machine Base
Workbench
Lag Screw
Flat Washer
Another option is a "direct mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Figure 13. "Through Mount" setup.
Number of Mounting Holes ............................ 4
Dia. of Mounting Hardware Needed ..........
5
⁄
16
"