-4-
Model T28360 (Mfd. Since 11/18)
Controls &
Components
F. Slide Lock Knob: Locks saw carriage in
place for transport.
G. Water Pump w/Flow Control: Draws water
from tray and sprays it onto blade during
cutting operations. Flow control increases or
decreases water flow as needed.
H. Table Fence: Provides square edge to hold
workpieces against during cutting operations.
Refer to
Figures 1–2 and the following descrip-
tions to become familiar with the basic controls
and components of this machine. Understanding
these items and how they work will help you
understand the rest of the manual and stay safe
when operating this machine.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
A. ON/OFF Switch: Turns blade motor and
water pump
ON and OFF.
B. Bevel Lock Knob (1 of 2): Locks saw in
position for repeatable bevel cuts.
C. Bevel Limit Stops (2 of 4): Sets saw tilt at 0
and 45 degrees.
D. Locking Miter Gauge: Supports workpieces
at precise angles for repeatable miter cuts.
E. Hold-Down Bracket: Secures workpiece in
place during cutting operations.
Figure 1. Tile saw components (rear).
B
A
C
D
Figure 2. Tile saw components (front).
F
G
H
E