-26-
Model T28360 (Mfd. Since 11/18)
Aligning 45˚ Bevel Limit Stops
Figure 29. Adjusting bevel limit stop to 45°.
1. DISCONNECT MACHINE FROM POWER!
2. Remove clear blade guard (refer to Installing/
Changing Blade on Page 18).
3. Move carriage to one end of table.
4. With saw against 45˚ bevel stops and bevel
lock knobs tightened, place combination
square (with straightedge removed) against
table and blade, as shown in
Figure 28. Blade
should be flush with combination square.
Note: If the base of the combination square
contacts the abrasive rim, look for a consis-
tent gap along edge where the square meets
the blade.
Figure 28. Combination square placed against
table and blade.
Combination
Square
5. Move carriage to opposite end of table, and
repeat
Step 4.
— If table and blade are at 45° at both ends
of table, no adjustment is needed.
— If table and blade are not at 45° at one or
both ends of the table, proceed to
Step 6.
6. Loosen bevel lock knobs (see Figure 29).
7. Starting on end that is not at 45°, loosen jam
nut (see
Figure 29) on bevel limit stop bolt.
8. While holding combination square against
blade, adjust bevel limit stop bolt (see
Figure 29) until table and blade are at 45°,
then tighten jam nut.
9. Reposition scale pointer (see Figure 29) to
45°.
Bevel Lock
Knob (1 of 2)
Jam Nut
10. Re-install clear blade guard.
Scale Pointer
Bevel Limit
Stop Bolt