Model T27338 (Mfd. Since 01/15)
-14
-
This nailer may accidentally fire if
you work on it without disconnecting
it from air source. Always disconnect
air from nailer whenever clearing a
jammed nail/staple!
Clearing Jammed
Nails
6. Remove jammed nail (see Figure 17)
with pair of needle-nose pliers, then
replace driver guide.
Figure 16. Cap screws securing driver
guide.
7. Load new nail/staple magazine that
only contains clean, undamaged nails/
staples. DO NOT use dirty or damaged
nails/staples!
Figure 17. Jammed nail in discharge area.
Tools Needed Qty
Hex Wrench 4mm ..................................... 1
Needle-Nose Pliers .................................. 1
If the nailer does not fire nails/staples
when you strike the head cap, it can indi-
cate the nailer has jammed. A jammed nail
must be cleared before using the nailer
again.
To clear jammed nail from discharge
area:
1. DISCONNECT NAILER FROM AIR
SOURCE!
2. Pull magazine loader all the way back,
lock in top position, then remove nails/
staples.
3. Place scrap wood under nose of nailer
and strike head cap (see
Figure 10) to
ensure magazine is empty and make
sure all compressed air is expended.
4. Jammed nail/staple should now be vis-
ible; use needle nose pliers to remove
it from discharge area.
— If nail cannot be removed, continue
to
Step 5.
— Continue to
Step 7 when jammed
nail is removed.
5. Remove three cap screws shown in
Figure 16 that secure driver guide.
Driver
Guide
Jammed Nail
Содержание T27338
Страница 28: ......