Grizzly T10875, Руководство пользователя

Страница: 26 / 40

-24-
Model T10875 (Mfd. Since 01/15)
1. Install collet and bit.
2. Grasp tool firmly.
3. Turn tool ON.
4. Ease tool against workpiece using light pres-
sure.
Note: Always test bit on a scrap piece of
material similar to workpiece.
Using Rotating Shaft
5. Hand-tighten collet nut while pin wrench is
inserted into locking hole.
6. Tighten
1
⁄
3
of a turn with collet wrench (see
Figure 20). DO NOT over tighten.
The Model T10875 uses bits and cutters with a
1
⁄
8
"
diameter shaft. See the Grizzly catalog or website
for a complete listing of available bits and acces-
sories.
To install a bit:
1. DISCONNECT MACHINE FROM POWER!
2. Rotate collet nut until locking holes in rotating
shaft grip align (see Figure 19), then insert
pin wrench.
Installing Bits
Figure 19. Location of locking holes in rotating
shaft grip.
Rotating Shaft
Grip
Locking
Hole
Collet
Nut
3. Loosen collet nut by turning counterclock-
wise.
Note: DO NOT completely remove collet nut
from shaft.
4. Insert bit shank into collet.
Note: At least
1
⁄
2
" of bit shank should be
mounted into end of collet.
Failure to wear safety glasses while operat-
ing grinder could cause serious personal
eye injury.
Figure 20. Tightening rotating shaft collet.
Tool Bit
Shaft
Pin
Wrench