Grizzly T10875, Руководство пользователя

Страница: 16 / 40

-14-
Model T10875 (Mfd. Since 01/15)
Assembly
Using the hardware from the Inventory list on
Page 12, completely assemble the T10875 by
attaching the tool rest and safety shield.
To assemble grinder:
1. Attach safety shield to spark deflector using
(1) M4-.7 x 40 Phillips head screw, (1) 4mm
flat washer, (1) M4-.7 flange nut, as shown in
Figure 9.
2. Attach safety shield assembly to right side
of grinder using (2) M4-.7 x 8 Phillips head
screws with captive flat and lock washers, as
shown in
Figure 9.
3. Attach each tool rest to grinder using (2) 4mm
flat washers and (2) M4-.7 x 10 wing bolts, as
shown in
Figure 10.
The tool rest stabilizes the workpiece when grind-
ing. It must always be positioned correctly when
using the grinder to avoid the workpiece or the
operator's hands being pulled into grinding wheel.
As the grinding wheel wears, loosen the wing
bolt and adjust the tool rest closer to the grind-
ing wheel to maintain a gap of
1
⁄
16
" –
1
⁄
8
" (see
Figure 11), then retighten the wing bolt. If the gap
reaches
1
⁄
8
" and no additional adjustments can be
made, replace the grinding wheel.
Tool Rest Adjustment
Some grinding wheels must be replaced
before spark deflector or tool rest reach
their final adjustment. As diameter of a
grinding wheel is reduced, so is available
surface speed. Grinding under these condi-
tions can lead to faster abrasive loss and
poor grinding results. Always follow wheel
manufacturer's directions.
NEVER grind without tool rest in place and
properly positioned. "Free hand" grinding
or too large of a gap between wheel and
tool rest increases risk of kickback, which
may lead to serious injury.
Figure 11. Example of correct tool rest gap.
1
⁄
16
" –
1
⁄
8
"
Figure 9. Safety shield assembly attached to
grinder.
Spark
Deflector
Safety
Shield
x 1
x 2
Figure 10. Tool rests attached to grinder.
Left
Tool Rest
Right
Tool Rest
x 2