Grizzly T10814, Руководство пользователя

Страница: 34 / 44

-32-
Model T10814 (Mfd. Since 5/15)
Belt Tension &
Replacement
The belt transfers power from the motor to the
drive pulley. An improperly tensioned belt will
slip, which quickly causes a loss of power and
may damage the belt. Therefore, it is essential to
properly maintain belt tension.
Pulley
Deflection
Pulley
Figure 35. Correct timing-belt deflection.
1
⁄
8
"
1. DISCONNECT MACHINE FROM POWER!
2. Remove cover to access belt and motor
mount (see Figure 33).
3. Loosen motor mount cap screws (see Figure
34).
5. Re-install belt cover.
Figure 34. Location of motor mount cap screws.
4. Push motor toward back of machine using
light/moderate pressure, then tighten motor
mount cap screws.
The belt is correctly tensioned when there
is approximately
1
⁄
8
" deflection when it is
pushed with moderate pressure, as shown in
Figure 35.
4. Roll belt off of drive pulley, then off of motor
pulley.
5. Insert new belt in motor pulley, then pull onto
drive pulley. This belt stretches easily and will
slip into place.
6. Tension the belt (see Tensioning Belt for
detailed instructions).
7. Re-install belt cover.
Figure 33. Belt and pulley components.
Motor Pulley
Drive Pulley
Tools Needed Qty
Hex Wrench 4mm .............................................. 1
Hex Wrench 5mm .............................................. 1
1. DISCONNECT MACHINE FROM POWER!
2. Remove grinding wheel.
3. Remove cover to access belt and pulleys
(see Figure 33).
Replacing Belt
Tensioning Belt