Grizzly QUIET Series, Руководство пользователя

Страница: 17 / 40

Model T32335 (Mfd. Since 11/20)
-15-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Locate machine in well-ventilated area at
least 18 inches from nearest wall or any other
obstructions.
The Test Run consists of verifying the following:
1) The motor powers up and runs correctly, 2)
the motor and pump turn
OFF when the cut-out
pressure is reached, and 3) the safety relief valve
works correctly.
5. Connect machine to power supply.
6. Move pressure switch lever to AUTO posi-
tion to turn machine ON and verify motor
operation.
The motor should run smoothly and without
unusual problems or noises.
4. Turn drain valve handle to open position (see
Figure 11).
Figure 11. Drain valve handle open.
Drain Valve
Handle
Figure 10. Location of pressure switch lever.
Pressure Switch
Lever
Eye injury hazard! Always
wear safety glasses when
handling pressurized air
system.
3. Move pressure switch lever to OFF position
(see Figure 10).