Grizzly H8172, Руководство пользователя

Страница: 14 / 28

-12- H8172 Cement Mixer
5. With the help of another person, place the
lower drum on the frame assembly, as shown
in
Figure 8. The gear guard MUST remain
installed on the lower drum. If, for any rea-
son, it is not installed in the location shown in
Figure 8, then install it now.
6. Attach the bearing block to the frame with
one M8-1.25 x 60 hex bolt on one side and
one 8mm flat washer, lock washer, and hex
nut on the other side (
see Figure 9).
Figure 8. Lower drum on frame.
8. Attach the lower end of the mixing blades
to the lower drum, placing a plastic wash-
er between the mixing blade and the drum
mounting holes (
see Figure 11). At each
attachment, use an M10-1.5 x 20 Phillips
head screw on one side and a 10mm flat
washer, lock washer, and hex nut on the
other side. Leave the fasteners loose for now.
Note: Since these fasteners will be regu-
larly exposed to water, we suggest coat-
ing them with anti-seize or bearing grease
before assembly to prevent them from rusting
together. Repeat this process on the fasten-
ers used in
Steps 9–10, as well.
7. Place the upper bracket over the pivot shaft,
and attach the upper bracket to the frame
with two M8-1.25 x 20 hex bolts on one side
and two 8mm flat washers, lock washers, and
hex nuts on the other side (
see Figure 10).
Figure 9. Bearing block installed over shaft and
attached to frame.
Figure 10. Upper bracket installed.
Figure 11. Lower end of mixing blades attached
to lower drum.
Gear Guard
Hex Bolt
M8-1.25 x 60