Grizzly G8689, Руководство пользователя

Страница: 10 / 44

-8-
G8689 Mini Mill (Mfg. 8/06+)
Additional Safety Instructions for Mini Mill
No list of safety guidelines can be complete.
Every shop environment is different. Always
consider safety first, as it applies to your
individual working conditions. Use this and
other machinery with caution and respect.
Failure to do so could result in serious per-
sonal injury, damage to equipment, or poor
work results.
Like all machines there is danger associ-
ated with the Model G8689. Accidents are
frequently caused by lack of familiarity or
failure to pay attention. Use this machine
with respect and caution to lessen the pos-
sibility of operator injury. If normal safety
precautions are overlooked or ignored, seri-
ous personal injury may occur.
1. UNDERSTANDING CONTROLS. Make
sure you understand the use and operation
of all controls.
2. SAFETY ACCESSORIES. Always use the
chip guard in addition to your safety glasses
when milling to prevent bodily injury.
3. WORK HOLDING. Before starting the
machine, be certain the workpiece has been
properly clamped to the table. NEVER hold
the workpiece by hand when using the mill.
4. CHUCK KEY SAFETY .
Always remove
your chuck key, drawbar wrench, and any
service tools immediately after use.
5. SPINDLE SPEEDS. Select the spindle
speed which is appropriate for the type of
work and material. Allow the mill to gain its
full speed before beginning a cut.
6. POWER DISRUPTION. In the event of a
local power outage during use of the mill,
turn
OFF all switches to avoid possible sud-
den start up once power is restored.
7. SPINDLE DIRECTION CHANGES. Never
reverse motor direction while the mill is in
motion.
8. STOPPING SPINDLE. DO NOT stop the
mill using your hand against the chuck.
9. BE ATTENTIVE. DO NOT leave mill run-
ning unattended for any reason.
10. MACHINE CARE AND MAINTENANCE.
Never operate the mill with damaged or
worn parts. Maintain your mill in proper
working condition. Perform routine inspec-
tions and maintenance promptly. Put away
adjustment tools after use.
11. DISCONNECT POWER. Make sure the mill
is turned
OFF, disconnected from its power
source and all moving parts have come to
a complete stop before starting any inspec-
tion, adjustment, or maintenance proce-
dure.
12. AVOIDING ENTANGLEMENT. Keep loose
clothing articles such as sleeves, belts or
jewelry items away from the mill spindle.
13. TOOL HOLDING. Always use the proper
tools for the material you are milling. Make
sure they are held firmly in the proper tool
holder for the job.
14. CLEAN-UP. DO NOT clear chips by hand.
Use a brush, and never clear chips while the
mill is turning.
15. CUTTING TOOL INSPECTION. Inspect
drills and end mills for sharpness, chips,
or cracks before each use. Replace dull,
chipped, or cracked cutting tools immedi-
ately. Handle new cutting tools with care.
Leading edges are very sharp and can
cause lacerations.