Grizzly G4179, Руководство пользователя

Страница: 24 / 40

-22-
Model G4179 (Mfd. Since 01/22)
The Model G4179 power feeder has the ability
to feed a workpiece at four different feed rates:
9.5, 15, 25, and 38 feet per minute. These rates
are achieved by changing the combination of
change gears in the power feeder gearbox (see
Figure 15).
Changing Feed
Speed
Figure 15. Change gear locations.
Position
B
Position
A
Included Accessory Change
Gears (26T and 34T)
Figure 16. Change gear chart.
Installed Change Gears:
A, 20-Tooth + B, 40-Tooth = 9.5 Feet Per Minute
A, 40-Tooth + B, 20-Tooth = 38 Feet Per Minute
Included Accessory Change Gears:
A, 26-Tooth + B, 34-Tooth = 15 Feet Per Minute
A, 34-Tooth + B, 26-Tooth = 25 Feet Per Minute
= Motor OFF
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
To change feed speed:
1. Turn feed direction switch to OFF position.
2. DISCONNECT MACHINE FROM POWER!
3. Refer to change gear chart below to find gear
combination for desired feed rate.
4. Remove gearbox cover and (2) 14mm hex
nuts securing position A & B change gears to
shafts.
5. Swap required gears in positions A & B
shown in Figure 15.
Note: Accessory gear set is located under-
neath gearbox cover as shown in
Figure 15.
6. Reinstall hex nuts and gearbox cover.