Model G1066R/Z/G1079R (Mfd. Since 02/11)
-21-
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 55) Qty
A. Drum Sander (Not Shown) ......................... 1
B. Crank Handle ............................................. 1
C. 4" Dust Ports .............................................. 2
D. Self-Tapping Screws #8 x
1
⁄
2
" ..................... 8
E. Flat Washers 10mm ................................... 8
F. Sandpaper Clips (G1066R, G1079R) ......... 2
G. Control Panel (G1066Z) .............................. 1
H. Hex Bolts
5
⁄
16
"-18 x 1" (G1066Z) ................. 2
I. Flat Washers
5
⁄
16
" (G1066Z) ....................... 2
J. Front Panel (G1066Z) ................................. 1
K. Self-Tapping Screws #8 x
3
⁄
8
" (G1066Z) ..... 8
L. Hex Wrench 3mm ....................................... 1
Site Considerations
Weight Load
Refer to the
Machine Data Sheet for the weight
of your machine. Make sure that the surface upon
which the machine is placed will bear the weight
of the machine, additional equipment that may
be installed on the machine, and the heaviest
workpiece that will be used. Additionally, consider
the weight of the operator and any dynamic load-
ing that may occur when operating the machine.
Space Allocation
Consider the largest size of workpiece that will
be processed through this machine and provide
enough space around the machine for adequate
operator material handling or the installation of
auxiliary equipment. With permanent installations,
leave enough space around the machine to open
or remove doors/covers as required by the main-
tenance and service described in this manual.
Physical Environment
The physical environment where the machine is
operated is important for safe operation and lon-
gevity of machine components. For best results,
operate this machine in a dry environment that is
free from excessive moisture, hazardous chemi-
cals, airborne abrasives, or extreme conditions.
Extreme conditions for this type of machinery are
generally those where the ambient temperature
range exceeds 41°–104°F; the relative humidity
range exceeds 20%–95% (non-condensing); or
the environment is subject to vibration, shocks,
or bumps.
Electrical Installation
Place this machine near an existing power source.
Make sure all power cords are protected from
traffic, material handling, moisture, chemicals, or
other hazards. Make sure to leave enough space
around machine to disconnect power supply or
apply a lockout/tagout device, if required.
Lighting
Lighting around the machine must be adequate
enough that operations can be performed safely.
Shadows, glare, or strobe effects that may distract
or impede the operator must be eliminated.
Site Considerations
Figure 55. Inventory.
G
J
I
H
D
E
F
C
B
K
L
