Figure 1.
Improper connections of the electrical-grounding
conductor can result in risk of electric shock. The
conductor with green or green and yellow striped
insulation is the electrical-grounding conductor. If
repair or replacement of the electric cord or plug
is necessary, do not connect the equipment
grounding conductor to a live terminal.
Under no circumstances should the grounding
pin from any three-pronged plug be removed. If it
will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Check with a qualified electrician or one of our
service personnel if the grounding instructions
are not completely understood, or if in doubt as to
whether the tool is properly grounded. Use only
3-wire extension cords that have 3-prong ground-
ing type plugs and 3-hole receptacles that accept
the tool’s plug.
FIgure 1.
Repair or replace damaged or worn cord immedi-
ately.
-4-
G1032 Dust Collector
110V Wiring
Your Model G1032 Dust Collector operates ideal-
ly at 110V, single phase power. The 1 HP motor
will draw roughly 8 amps at 110 volts. These
loads are not excessive, but if you operate your
machine on any circuit that is already close to
capacity, it might blow a fuse or trip a circuit
breaker. If an unusual load does not exist, and
power failure still occurs, consult a qualified elec-
trician. Otherwise, consider a dedicated circuit for
your machine.
A 110V plug is provided with the G1032.
In the case of 220V operation, please call the
service department for further information.
Grounding
CAUTION:
THIS TOOL MUST BE GROUNDED
WHILE IN USE TO PROTECT THE OPERATOR
FROM ELECTRIC SHOCK.
In the event of a malfunction or breakdown,
grounding provides a path of least resistance for
electric current to reduce the risk of electric
shock. This tool is equipped with an electric cord
having an equipment-grounding conductor. The
grounding conductor must be connected to the
grounding pin on the plug. The plug must be
plugged into a matching outlet that is properly
installed and grounded in accordance with all
local codes and ordinances.
SECTION 2: CIRCUIT REQUIREMENTS