Grizzly G1021X2, Руководство пользователя

Страница: 48 / 76

-46-
G1021X2 & G1021Z (Mfd. Since 08/16)
13. loosen jam nuts and set screws on each side
of chip breaker (see figure 59).
14. using a feeler gauge, adjust set screw so it is
0.040" from cross bar (see
figure 59), then
tighten jam nut. repeat on other side of chip
breaker.
15. re-install belt cover, top cover, drive chain
cover, and dust port.
Adjusting Roller
Spring tension
figure 59. Example of feeler gauge locations for
adjusting chip breaker height when using wood
blocks.
Cross Bar
Jam nut &
Set Screw
insert
Feeler
gauge
here
the infeed and outfeed rollers keep the workpiece
moving through the planer. Springs exert down-
ward pressure on the rollers while allowing them
to raise with an uneven workpiece surface. proper
roller spring tension is crucial to keep the work-
piece moving through the planer during operation.
roller spring tension will vary depending upon the
type of wood you are planing. When adjusting the
roller spring tension, keep the following in mind:
• if you are planing milled lumber with a rel-
atively consistent surface, use less spring
tension to reduce the risk of marring the
workpiece surface.
• if you are planing rough lumber with incon-
sistent surfaces, use greater spring tension
to keep the stock moving through the planer.
• if the workpiece consistently stops feeding
during operation, the roller spring tension
may need to be increased.
items Needed Qty
hex Wrench 5mm .............................................. 1
figure 60. Example of roller spring tension
adjustment screws.
tension
Screws
to adjust roller spring tension:
1. diSConnECt MaChinE FroM poWEr!
2. rotate tension screws (shown below)
clockwise to increase tension or counter-
clockwise to decrease tension.