Grizzly G1021X2, Руководство пользователя

Страница: 38 / 76

-36-
G1021X2 & G1021Z (Mfd. Since 08/16)
feed Roller bushings
oil type ................SB1365 or iSo-68 Equivalent
oil amount ...........................................2–3 drops
Frequency ................ Every 8 hours of operation
the infeed and outfeed rollers rotate inside bush-
ing blocks on both ends of the rollers. add 2–3
drops of iSo 68 machine oil to the center hole of
the four feed roller tension adjustment bolts on top
of the head casting, as shown in
figure 42.
table height chain & Sprockets
grease type ..........................nlgi#2 Equivalent
Frequency ............ Every 160 hours of operation
the table leadscrews are synchronized by the
table height chain and sprockets located under-
neath the planer base (see
figure 45). use shop
rags and mineral spirits to clean away debris and
grime, then brush on a light coat of multi-purpose
grease to the chain and sprockets.
figure 45. Example of table height chain and
sprockets as viewed from underneath the base.
table height Worm Gear
grease type ..........................nlgi#2 Equivalent
Frequency ............ Every 160 hours of operation
remove the three cap screws that secure the
worm gear housing (see
figure 44), then lift
the housing and handwheel assembly off the
machine. Clean away any debris from the housing
and gears, then brush on a moderate amount of
multi-purpose grease to the gear teeth.
columns & Leadscrews
oil type ................SB1365 or iSo-68 Equivalent
oil amount ............................................thin Coat
grease type ..........................nlgi#2 Equivalent
Frequency .............. Every 40 hours of operation
the table rides on the columns and is moved by
the rotation of the leadscrews inside the columns.
loosen the dust sleeve (see
figure 43) to access
the columns and leadscrews. apply a thin coat of
iSo 68 machine oil to the outside surface of the
columns and brush on a light application of multi-
purpose grease to the leadscrew threads. Move
the table up and down to distribute the lubricant.
figure 43. location of column and leadscrew.
Column
leadscrew
figure 42. Example of lubrication locations for
feed roller bushings.
lubricate
here
figure 44. Example of table height worm gear
housing.
Worm gear
housing
Cap Screws
(1 of 3)