Grizzly G0926, Руководство пользователя

Страница: 24 / 56

-22-
Model G0926 (Mfd. Since 11/20)
Disabling Switch
Figure 20. Disabling switch by removing key.
The switch can be disabled by removing the key,
as shown below. Disabling the switch in this man-
ner can prevent unauthorized operation of the
machine, which is important if it is not kept inside
an access-restricted building or in a location
where children may be present.
IMPORTANT: Disabling the switch only restricts
its function. It is not a substitute for disconnecting
machine from power when adjusting or servicing.
Children or untrained people can be
seriously injured by this machine. This
risk increases with unsupervised operation.
To help prevent unsupervised operation,
always disable switch before leaving
machine unattended. Make sure to place
key in a well-hidden or secure location!
The following tips will help you safely and effec-
tively operate your bandsaw, and help you get the
maximum life out of your saw blades.
Loosen blade tension at the end of each day
to prolong blade life.
Operation Tips
Tips for cutting:
• Use the work stop to quickly and accurately
cut multiple pieces of stock to the same
length.
• Clamp workpiece firmly in the vise jaws to
ensure a straight cut through the material.
• Allow blade to reach full speed before engag-
ing the workpiece. Never start a cut with the
blade in contact with the workpiece, and do
not start a cut on a sharp edge.
• Chips should be curled and silvery. If the
chips are thin and powder-like, increase your
feed rate (refer to the
Metal Chip Inspection
Chart on Page 26).
• Burned chips indicate a need to reduce blade
speed.
• Wait until blade has completely stopped
before removing workpiece from vise. Avoid
touching the cut end—it could be very hot!
• Support long pieces so they will not fall when
cut. Flag long ends to alert passers-by of
potential danger.
• Adjust blade guides as close as possible to
the workpiece to minimize side-to-side blade
movement.